PCBA FOR MEGA2560 R3 CONTROL BOARD
₹ 1198.88 (incl Of all taxes)
₹ 1016 + 18 % Gst + Delivery to pay
₹ 1415
In Stock
About This Product
- You can supply power to the plate via the USB connector or power the pinheaders. The regulator can deal with inputs of 6 V to 9 V 18 V) for output current for 5 V approximately 800 mA, for 3.3 V approximately 800 mA/ATmega2560 version, for board.
- The table has a compact size of 12 x 8 x 3 cm. It's a good solution, to do your project in welding protoplasm.
- Built in the ATmega2560 microcontroller and USB-UART CH340G chip.
- Plate for functionality similar to the It is plate, but the same stable, and uses ATmega2560 (16 MHz) chips.
- CH340G Replace ATega16U2.
- Microcontroller: ATmega2560.
- Operation of 5 V.
- Entry (recommended): 7-12 V.
- Entrance: 6-20 V.
- Digital I/S pins: 54 (of which 15 provide output).
- Steps from the incoming: 16.
- For current per pin of I/O: 40.
- For streams for 3.3 V pins: 50.
- Memory: 256 of which 8 used by the boot charger.
- 8 units.
- EEPROM: 4.
- Clock speed: 16 MHz.
- Approximate size: 12 x 8 x 3 cm.
- CH340G Replace ATega16U2.
- Microcontroller: ATmega2560.
- Operation of 5 V.
- Entry (recommended): 7-12 V.
- Entrance: 6-20 V.
- Digital I/S pins: 54 (of which 15 provide output).
- Steps from the incoming: 16.
- For current per pin of I/O: 40.
- For streams for 3.3 V pins: 50.
- Memory: 256 of which 8 used by the boot charger.
- 8 units.
- EEPROM: 4.
- Clock speed: 16 MHz.
- Approximate size: 12 x 8 x 3 cm.